| |
|
|
| |
 |
 |
BEAM FRAME
The vertical double decks beam frame makes good use of available
space. The adjustable bracket gives a wider applicable beam range.
The maximum adjustment range is 400 mm. There is space between every
two beam frames for convenient taking care of warp breaking. It
is well built in structure, style in appearance and free of vibration
and noise. |
| |
|
|
|
DRYING CYLINDERS
The stand is constructed with H type steel, and covered with iron
plate. This fully closed construction will reduce heat consumption
and improves operation environment. The cylinder is welded with 3
mm stainless plate. It's maximum load pressure is 5kg/cm2. These six
cylinders nearby sizing box are coated with Teflon layer, to prevent
sticking of sizing material. These four pre-dry cylinders directly
after the sizing box is driven by cone-drum mechanism to adjust velocity
differentiation with the cylinders in later sections. Equipped with
multiple sets of temperature controller, it can be accurately controlled
by panel presetting.
|
|
|
|
SIZING DEVICE
The effect of double dipping and double pressing process reduce the
sizing cost. With the hi-pressure sizing press design, the pressure
of outlet press roller could reach 2500kg. The tension adjustment
of sizing box is separated with inlet and outlet section. The buffer
device can precisely control inlet tension. The differential device
can precisely control warp draft ratio in about 1%. These sizing boxes
are constructed with two decks, and are equipped with automatic controller
to keep it in even temperature.
|
|
TAKE UP DEVICE
The construction is divided into mainframe and sub-frame. The sub-frame
is equipped with reed, measuring, taking up, and guiding roller.
When machine is running, the whole set of sub-frame will jog tidy
left and right to make the winding up even smoother. The zigzag
stretchy reed is adjusted by a motor. While the machine is running,
it will automatically jog up and down.
|
|
1.
|
There is 3 stages of speed control:
|
2.
|
Beam winding selection is divided into 2 section:
|
|
|
• Crawl speed: 0.8 M/min. |
|
• 100 ~ 750 |
|
• High-speed: max speed up to 100M/min.
|
• 1140 ~ 1000
|
|
• Low speed: max speed up to 60M/min.
|
• It's available for all kinds of beam
specifications.
|
|
|
|
|
 |
YARN PRESS AND BEAM
No need for digging ground holes, the installation is simple. The
beam doffing mechanism is controlled by air pressure, and maximum
loading capacity is 1200kg. The yarn press mechanism is also controlled
by air pressure, maximum pressure is 240kg. |
| |
|
 |
YARN SEPARATION AND WAXING
The separating rod can be vertically adjusted for 280mm. It is big
enough for separating each layer. The options in waxing processes
are single side, twin side or non-waxing. The wax tank is equipped
with automatic temperature controller. |
| |
|
 |
 OPTIONAL
DEVICE
1. Draft ratio controller.
2. Moisture regain
controller.
3. Sizing
pick up controller.
4. Micro control device.
5. IT type keyboard panel.
|
| |
|
